E3D SuperVolcano Upgrade Kit - 3.00 mm

Upgrade your E3D hot-end with the SuperVolcano so that you can print extremely quickly even at high temperatures. Choose either the starter kit with a 1.00 mm brass nozzle or the eruption kit with 4 different brass nozzles. Additional nozzles are available for printing on different materials.

Print faster

The SuperVolcano has up to 11 times volumetric filament flow as the normal V6 hot end. This ensures an extreme increase in printing speed.

High temperatures

The SuperVolcano can inherently reach a temperature of 285 ° C, and if you replace your thermistor with a Thermocouple or PT100, you can even exceed 400 ° C. Print everything from PLA to PEEK!

Selection of nozzles

Try a wide range of nozzle materials and sizes. It has been found that using a 1.00mm nozzle gives the best combination of speed and detail.

Good adhesion between the layers and on the print bed

Print wider and higher layers - this provides a larger area so models have better adhesion to the bed. Less warping!

Compatible with the E3D ecosystem

This SuperVolcano upgrade kit is fully compatible with the E3D hot-end range. Simply attach it to your V6, Titan Aero, Titan Aqua and Chimera +.

Space for a second thermistor

If you want additional monitoring of your hot end performance, you can add another thermistor!

Contents starter pack

• 1 x Plated Copper SuperVolcano heating block
• 1 x thermistor
• 1 x thermistor extension cable
• 1 x silicone glass fibre tube
• 1 x 80W heating cartridge
• 1 x brass nozzle 1.00 mm
• 1 x thermal paste
• 4 x M3 grub screws
• 1 x Allen key

If 12V:

• 1 x Mosfet board
• 1 x Mosfet cable

Content eruption pack

• 1 x Plated Copper SuperVolcano heating block
• 1 x thermistor
• 1 x thermistor extension cable
• 1 x silicone glass fibre tube
• 1 x 80W heating cartridge
• 4 x brass nozzle 0.80 mm, 1.00 mm, 1.20 mm and 1.40 mm
• 1 x thermal paste
• 4 x M3 grub screws
• 1 x Allen key

If 12V:

• 1 x Mosfet board
• 1 x Mosfet cable