BondTech NEMA17 Pancake Stepper 25mm

Questions & Answers about BondTech NEMA17 Pancake Stepper 25mm

Receive answers from other customers who purchased this product. Please forward any other order-related questions to our Customer Service Team.

• Does this motor really have a designed running voltage of 2.9 Vdc/phase (from the spec sheet)? Are you sure it isn't higher, maybe 12 Volts?

  1 Answer, last answered on March 22 2021

  Answer this question

  • Andrew

    March 22 2021

    Customer Service

    It is correct, the stepper drivers will cut the voltage from the power supply's 12/24v to a voltage that is suitable for stepper motors.

• Hi, i have changed my Ender 3 to a Direct Drive system but looking for a lighter stepper motor for it would this work for my Direct Drive Extruder? Thanks in Advance

  1 Answer, last answered on October 19 2022

  Answer this question

  • Andrew

    October 19 2022

    Customer Service

    I'm assuming you upgraded to the Micro-Swiss direct drive upgrade? If so then this motor is not suitable because the shaft is round, you need one that has a flat side for the gear to be attached. Luckily we have one right here: https://www.3djake.uk/bondtech/nema17-pancake-stepper-22mm

• Compare with creality 42-40 how close or far is it?

  This question has not been answered yet.

  Answer this question

• If I was to upgrade my creality printer to a direct drive would this motor upgrade just be plug and play?

  This question has not been answered yet.

  Answer this question

• hi will this stepper fit my original bondtechh for prusa mk3 thanks

  This question has not been answered yet.

  Answer this question

• Will this work with a microswiss hotend and direct drive kit

  1 Answer, last answered on June 27 2022

  Answer this question

  • Andrew

    June 27 2022

    Customer Service

    No the shaft needs to be flat to fit the MS gear. This one is suitable though: www.3djake.uk/bondtech/nema17-pancake-stepper-22mm

• Can this be used to replace extruder motor on microswiss direct drive?

  1 Answer, last answered on November 19 2020

  Answer this question

  • Andrew

    November 19 2020

    Customer Service

    The drive gear on the Micro Swiss direct drive kit require a tapered motor shaft which this motor doesn't have but we have a suitable one here: https://www.3djake.uk/bondtech/nema17-pancake-stepper-22mm