CNC Kitchen Volcano Adapter V2

The brass alloy Volcano Adapter V2 has been specifically designed for use with Bondtech's CHT nozzle to improve the flow performance of a Volcano hotend with a V6 nozzle. The adapter is also compatible with all other standard length V6 nozzles!

The lead- and cadmium-free adapter is designed for temperatures of up to 300°C max. and is suitable for all types of materials - including abrasive materials such as CF, wood and glow-in-the-dark filaments.

Tip: Since the nozzle with adapter is harder to purge than a standard nozzle, you should consider cold pulling if you change materials and colours regularly. Changing your usual print settings is not necessary when using the adapter.

Warning! The hotend temperature should not exceed 240°C when tightening the adapter as this can cause the material to lose strength and break!

Installation of the adapter in a Volcano hotend

► Tools required:

• 2 mm Hex key (do not use a Ball End Hex key!)
• Pliers to get a firm grip on the heater block.

► Individual installation steps:

1. Heat the hotend (do not exceed 240°C!).
2. Remove the Volcano nozzle.
3. Plug the adapter onto the enclosed 2.0 mm Hex key. Make sure it fits perfectly.
4. Fix the heating block with pliers and carefully screw the adapter into the heating block from below. If you feel resistance when screwing it in, you may have to clean the thread first. Be careful not to strip the hex!
5. Tighten the adapter with a torque of approx. 0.5-1.0 Nm. The force you use shouldn't be as strong as with a jet.
6. Install a standard length V6 nozzle as usual.

Remember to leave a small gap between the nozzle and the heater block. This is to ensure that you have tightened the nozzle against the adapter and not against the heating block. If this is not the case, plastic could escape through the thread.

Contents:

• 1 x Volcano Adapter V2
• 1 x 2mm Hex key