Alveo3D Filter P4D

The Alveo3D Filter P4D sets new standards in air filtration for FDM 3D printers. With an efficiency of 99.995% for the most penetrating particle sizes (MPPS) of 0.3 μm, this HEPA14 filter is one of the best in its category. Compared to HEPA13 filters, the P4D offers superior particle filtration and thus ensures a clean working environment.

Tip: The filter also contains activated carbon granules made from coconut shells with a size of 1 to 3 mm.

Handling instructions:

• Care must be taken when handling the filter. Damage to the white, pleated surface of the HEPA14 filter may affect its effectiveness.

• Be sure to wear gloves when changing the filter and dispose of it in the zip bag provided, as saturated filters are not recyclable.

• Filter life depends on several factors, including the type of filament used, melting temperature, concentration of nanoparticles and VOCs, and the relative humidity in your work area.

• To ensure best performance, it is recommended that the housing support for the filter be no smaller than 156mm x 156mm, as excessive compression could distort the geometry of the frame.

► It is recommended to replace the filter after 4 months of intensive use and after 8 months of occasional use.

Technical specifications: