Unfortunately, we don't sell these seperately

It would be quite difficult as the plate is made of steel. But we have other cuttable flex plates like those from Zimple

Yes but I don't think the auto-levelling would work well

Normally it should be but we would nevertheless advise caution while doing it.

The installation of the flexplate can be a bit complicated - this step by step video will be very helpful in installing it correctly. https://www.youtube.com/watch?v=ogG37ou9b9s

Currently, there is no Flexplate size that exactly fits the build plate of the Ultimaker 3 but we're hoping Buildtak will release an appropriately sized plate in the near future.

Hi Clifford, thanks for your question. Unfortunately, Buildtak do not currently make a flexplate in the right size for the Ender 3.

8 questions in English for BuildTak FlexPlate System

25 Questions in different languages

8 questions in English for BuildTak FlexPlate System

25 Questions in different languages

Buy product

Filter questions and answers:

Which is the right size to be purchased for the Artillery Sidewinder X2?

This question has not been answered yet.
Is it possible to buy additional flexible steel plates (without the magnetic base) so I can have different plates with different coatings

1 Answer, last answered on January 19 2022
- Andrew
  
  January 19 2022
  
  Customer Service
  
  Unfortunately, we don't sell these seperately
Please, is it possible to cut the magnetic plate to required dimensions without damging it ? I would like to buy one for my flashforge creator (230x150mm)

1 Answer, last answered on December 02 2021
- Andrew
  
  December 02 2021
  
  Customer Service
  
  It would be quite difficult as the plate is made of steel. But we have other cuttable flex plates like those from Zimple
Could this be used on a zortrax M300 plus?

1 Answer, last answered on November 02 2021
- Andrew
  
  November 02 2021
  
  Customer Service
  
  Yes but I don't think the auto-levelling would work well
Is the magnet strong enough to allow a full build plate print with filamentum nylon CF 15 Carbon

1 Answer, last answered on December 17 2019
- Bianca di 3DJake Italia
  
  December 17 2019
  
  Customer Service
  
  Normally it should be but we would nevertheless advise caution while doing it.
I've got a glass build plate fixed with binder clips, do I remove the glass plate and fix this direct to the heated bed or fix the the glass?

1 Answer, last answered on September 11 2018
- Andrew
  
  September 11 2018
  
  Customer Service
  
  The installation of the flexplate can be a bit complicated - this step by step video will be very helpful in installing it correctly.
  
  https://www.youtube.com/watch?v=ogG37ou9b9s
Will this fit an Ultimaker 3?

1 Answer, last answered on August 17 2018
- Andrew
  
  August 17 2018
  
  Customer Service
  
  Currently, there is no Flexplate size that exactly fits the build plate of the Ultimaker 3 but we're hoping Buildtak will release an appropriately sized plate in the near future.
Will this become available in a size for the Creality Ender 3 235mm x 235mm

1 Answer, last answered on July 09 2018
- Andrew
  
  July 09 2018
  
  Customer Service
  
  Hi Clifford, thanks for your question. Unfortunately, Buildtak do not currently make a flexplate in the right size for the Ender 3.